*laugh*
After this much begging. . . I will take ANY version I can get. All
I need is a side profile and a head on shot to get the contours
down. After that, I can tweak the model as needed. Quarter angles
and rear shots would be icing on the cake, but by no means
necessary.
-Nehumanuscrede
--- In SkunkworksAMA_at_y..., "jmhcustomart" <jmhcustomart_at_y...> wrote:
> --- In SkunkworksAMA_at_y..., "nehumanuscrede" <nehumanuscrede_at_y...>
> wrote:
> > As far as getting a 3D version of Des going. . . . I still have
> never
> > seen an accurate model sheet of the Des character that I've been
> > begging for. . . even went so far as to ask for a commission on
the
> > piece, but never received a reply from either Des or Jim. *sigh*
> > Without an accurate reference model, I am unable to begin playing
> > with the idea. ( front, side profiles are ideal, top would be
> icing
> > on the cake )
> >
> > I DO have the technological capability of producing the character
> in
> > 3D, ( go find my Yahoo profile ) but need something to start
> from. :)
> > Nudge, nudge, hint, hint, wink, wink. . . . . .
>
> I could probably whip up a quick few sketches of her, but they
> wouldn't be cartoony, like Des draws herself. Which version would
> you prefer?
>
> --JMH
Received on Wed Dec 04 2002 - 15:39:42 CST